【厂家供应UL1581标准试料磨平机XL-8015哑铃试料磨片机塑料电线耐磨试验机】价格_批发_厂家_参数_图片_耐磨试验机

1/1

厂家供应UL1581标准试料磨平机XL-8015哑铃试料磨片机塑料电线耐磨试验机

¥4800.00

3-4台

¥4600.00

5-9台

¥4500.00

≥10台

产品规格

可售数量： 60台

东莞市禧隆电工机械设备有限公司

采通通 8 年资质认证实名企业

17年

经营年限

广东东莞

所在地区

10.0

综合评分

全部产品进入店铺

图文详情

产品属性

厂家供应UL1581标准试料磨平机XL-8015哑铃磨片机

试料磨平机在将橡胶或塑胶哑铃状试片磨平、磨薄或磨出所需之厚度，以供拉力、老化、耐油等试验之用。试片台左右、上下及前后之移动，以扳手操作。

符合UL1581标准第420.6条规定。

Buffing machine （AUGUST 2, 2006 - UL 1581）

420.6 A power-driven buffing machine (grinding wheel) is appropriate for buffing irregularities from the ples from which die-cut specimens are to be prepared. The abrasive wheel is to be of about No. 36 grit (particle size of 0.019 inch or 0.486 mm). The wheel is to run true and is not to vibrate. The diameter of the wheel is not specified; however, 4-3/4 – 6-1/4 inch or 0.12 – 0.16 m has been found appropriate. The rotary velocity of the wheel is to be 2500 – 3500 r/min. The diameter and rotary velocity of the wheel are to be selected to give the wheel a peripheral speed (rpm×p×wheel diameter) of 3000 – 5000 ft/min or 15 – 25 m/s. CAUTION – The maximum wheel diameter stated in this paragraph and the maximum wheel rpm stated in this paragraph shall not be used together as this combination will result in a peripheral speed above 5000 ft/min or 25 m/s. This applies even for wheels that are marked as being intended for a peripheral speed above 5000 ft/min or 25 m/s. The machine is to have a slow feed that applies light pressure and removes very little material at one cut, thereby not overheating the specimen or the wheel.

主要技术参数

砂轮：36#； ø 5″

砂轮线速度：3000～5000feet/min或15～25m/s

皮带轮加速比：2：1

体积：50×60×40cm

重量：50kg

电源：1∮，AC220V 50Hz

注：以上价格有误，仅供参考，来电更多优惠！