【厂家直销,2020年推荐产品,生物质锅炉脉冲除尘器,燃煤锅炉，生物质蒸发器配套除尘器】价格_批发_厂家_参数_图片_脱硫除尘设备

1/1

厂家直销,2020年推荐产品,生物质锅炉脉冲除尘器,燃煤锅炉，生物质蒸发器配套除尘器

¥ 88000.00

10台起订

产品规格

规格: DMC120 DMC84 DMC96 LMCD1000 LMCD2000 LMCD3000 LMCD400 LMCD4000 LMCD6000 PPC32-5 PPC32-6

长沙麦迪环保设备有限公司

采通通 6 年资质认证实名企业

11年

经营年限

湖南长沙

所在地区

10.0

综合评分

全部产品进入店铺

图文详情

产品属性

要：厂家直销,2020年推荐产品,生物质锅炉脉冲除尘器,燃煤锅炉，生物质蒸发器配套除尘器，热风炉除尘器

根据锅炉燃料，锅炉吨位，选用DMC,PPC,LMCD的除尘器，由小型至中型至大型除尘器组成。

DMC（PMD）-MD系列喷吹脉冲单机袋式收尘器

DMC(PMD)-MD Series Jet-Pulse Unit Bag Filter

【概述Introduction】

l PDM(DMC)系列喷吹脉冲单机袋式收尘器适用于破碎、输送、提升、配料、库顶、库底、水泥散装等处的粉尘治理，可以连续工作，无须停机清灰

l 收尘器可分成不同的安装形式：不带灰斗及支腿型(B型)、带灰斗及支腿型（A型）；风机可90°、0°，根据需要选择

l 压缩空气必须保证0.5-0.7MPa的压力，否则影响清灰效果

l 除尘器本体采用碳钢、不锈钢等材质

l PMD(DMC) series jet-pulse unit bag filter is applicable for dust collecting in various sections, such as crushing, conveying, elevating, proportioning, silo top, silo bottom and bulk cement. It could operate continuously without necessity to stop the equipment for removing dust.

l The dust collector could be erectly in different ways: without hopper and bracing(B model); with hopper and long bracing（A model）; Fans can be set in 90°and 0°angles depending on requirements.

l Pressure of compressed air should be ensured within0.5-0.7MPA，or else operation for removing dust would not be efficient.

l Use the material such as carbon steel, stainless steel filter ontology.

【特点介绍Characteristics】

l 一般采用上箱体顶部设可掀起的盖板用于检修及更换滤袋，若空间受限可采用侧开门以便检修更换滤袋。

l 滤袋用特制的弹簧胀圈固定在多孔板上，滤袋内安装有金属框架和文氏管。

l 采用微机自动控制清灰

l 安装有防滤袋脱落网，更适合库顶使用

l General use case on the top cover plate for convenient maintenance and replacement of bag. If the space is limited side door can be used to repair replace the filter bag.

l Filter bag with a special spring ring fixed on the perforated plate , Metal frame and pipe installation within the filter bag

l Dust removal is controlled by computer automatically.

l A net is installed to avoid bag’s falling down to silo. It is more suitable for operation on top of silo.

【技术指标Technical Indexes】

l 收尘器入口含尘浓度一般低于200g/Nm³

l 收尘器排放浓度低于30mg/Nm³

l 收尘器滤袋寿命两年以上

l 收尘器运转率相对主机较好

l Dust concentration at inlet is below 200 g/Nm³.

l Emission concentration is below 20 mg/Nm³.

l Service life of filter bags is over 2 years.

l The operation rate of bag filter to equipment is 99.99%

PPC(FGM)-MD系列气箱脉冲袋收尘器

PPC(FGM) –MD Series Plenum Pulse Bag Filter

【概述Introduction】

PPC（FGM）系列袋收尘器主要适用于非爆炸性粉尘，可广泛应用于建材、冶金、电力等行业的破碎机、球磨机，立式磨、烘干机、O-Sepa 选粉机、立式冷却机、包装机等系统的收尘。

PPC(FGM) series bag filters are mainly applied to non-explosive dust. They are widely used to collect dust in crusher, ball mill, vertical mill, dryer, O-Sepa separator, grate cooler, packer, etc, in industries as building material, metallurgy, electrical power, etc.

【特点简介Characteristics】

l 能一次性处理含尘浓度高达1000g/Nm³烟尘

l 无需预收收尘设备，工艺流程简单

l 袋室内无需喷吹管，拆换袋方便

l 嵌入式弹性袋口，密封性能好

l 脉冲阀数量少，清灰强度大，动作迅速

l 整机采用微机自动控制，各控制参数易于调节，投入自动是，可实现无岗位工操作。

l Able to treat smoke with dust concentration 1000g/Nm³ at one time

l No equipment for pre-collecting dust is necessary，which brings out a simple process flow

l without jet pipe in bag chamber，it is convenient to replace bags

l The embedded elastic bag mouth helps in good sealing

l Number of pulse values is small; operation of removing dust is highly efficient

l The whole equipment is automatically controlled by computer. under automation mode，no person is needed for operation.

LMCD(CDMC)系列长袋脉冲布袋式除尘器

LMCD (CDMC) Series Long-Bag Pulse Bag Pulse Filter

【特点简介Characteristics】

l 设计新颖，采用下进气结构，较粗的高温颗粒直接落入灰斗，有效的保护了滤袋

l 采用长滤袋，在同等处理能力时设备占地面积少，更便于老厂改造

l 采用分室离线清灰，效率高，粉尘的二次吸附少，同时有效的降低了设备能耗，滤袋与脉冲阀的疲劳程度也相应降低，成倍地提高了滤袋和阀片的寿命，大量减少了设备运行维护的费用

l 检修换袋可在不停系统风机、系统正常运行的条件下分室进行

l 滤袋袋口采用弹簧涨紧结构，拆装方便，具有良好的密封性

l 箱体经过气密性设计，并以油捡漏，减少漏风

l 整台设备由PLC机控制，实现自动清灰、卸灰、自动温度控制及超温报警

l Hopper directly to effectively protect filter bags.

l With long bags, equipment takes less area compared with others in the same capacity. It is especially favorable for upgrading of existing plants.

l Off-line dust removal in separate chambers featured as follows: high efficiency: less secondary dust re-adhering: lower power consumption; extended service life of bags and valve plate due to less fatigue. in this way, expense for equipment maintenance could be greatly reduced.

l Maintenance and replacement of bag can be separately conducted in each chamber without interrupting the whole operation system and fans.

l Apply spring take-up at bag mouth for easy maintenance and replacement and favorable air tightness.

l The design of shell takes air tightness into consideration and use kerosene for inspection, so as to reduce air leakage to the largest extent.

l Equipment is controlled through PLC to realize automatic dust removal, dust discharge, temperature control and over-temperature alarming.