【JE 春晨 JE电机引接线电机引出线测量电流】价格_批发_厂家_参数_图片_电气设备用电缆

1/1

JE 春晨 JE电机引接线电机引出线测量电流

¥ 7.00

10米起订

产品规格

颜色: 黑

每卷长度: 100 200 300

江苏春晨电缆有限公司

10年

经营年限

江苏淮安

所在地区

5.9

综合评分

全部产品进入店铺

图文详情

产品属性

江苏春晨电缆有限公司生产 JE电机引接线， JE电机引接线，

在电气线路中，电路、电压是基本的量。电路有直流和交流之分，因此电流和电压也有直流电流、交流电流和直流电压、交流电压之分。专门用于测量电流的仪表叫电流表，专门用于测量电压的仪表叫电压表。测量电流和电压应注意以下三个问题：

In the electrical circuit, circuit and voltage are the most basic quantities. Circuits are divided into DC and AC, so current and voltage are also divided into DC current, AC current and DC voltage, AC voltage. The instrument specially used for measuring current is called ammeter, and the instrument specially used for measuring voltage is called voltmeter. The following three problems should be paid attention to in measuring current and voltage:

电流表必须与用电设备串联，电压表必须与用电设备并联；

Amperometers must be connected in series with electrical equipment, and voltmeters must be connected in parallel with electrical equipment.

根据被测量的大小，选择合适的量程。量程太大，测量不准确；量程太小，容易烧坏仪表。如果测量大小不能估计，可先选择量程，然后根据指针偏转的情况，适当调整至合适的量程测量。

According to the measured size, choose the appropriate range. The measurement range is too large, the measurement is inaccurate; the measurement range is too small, easy to burn out the instrument. If the measurement size can not be estimated, the maximum range can be selected first, and then adjusted to the appropriate range measurement according to the deflection of the pointer.

对直流的测量要注意仪表的极性，测量直流电流，接线应使电流从表的正极流进，负极流出；测量直流电压，应使表的正极接高电位端，负极接低电位端。

When measuring DC, we should pay attention to the polarity of the instrument, measure DC current, wiring should make the current flow from the positive pole to the negative pole of the meter, and measuring DC voltage should make the positive pole of the meter connect to the high potential end and the negative pole connect to the low potential end.